Resource Library
QuickHeat Hose Clamp Assembly Kit Manual 347553
- QuickHeat Hose Clamp Assembly Kit Manual 347553 [ English ]
347553
®
HOSE CLAMP ASSEMBLY KIT
SMART END: 347526
INSTALLATION GUIDE
PARTS/TOOLS:
Item Description Qty
a HOSE CLAMP TOP - SE 1
b HOSE CLAMP BOTTOM - SE 1
c 1/4-28 X 7/8 SHC SCREW 1
d 3/16 ALLEN WRENCH (NOT INCLUDED) 1
EN
www.binks.com347553 REV B (05/2025) © Binks US, LLC. All Rights Reserved
ELECTRICAL SHOCK HAZARD: Disconnect
all power sources before accessing any
electrical connections in the Control Module,
Fluid Modules, or hoses. Equipment must be
serviced by trained personnel only.
FIRE AND EXPLOSION HAZARD: Improper
equipment grounding, poor ventilation, open
flame or sparks can cause a hazardous
condition and result in fire or explosion and
serious injury.
NEVER MODIFY THE EQUIPMENT:
Do not modify the equipment unless the
manufacturer provides written approval.
WARNING
Read the following warnings before performing any
maintenance
CLAMP LOCATION
Fig. 1
EN
www.binks.com 347553 REV B (05/2025)© Binks US, LLC. All Rights Reserved
Remove old clamp:
1. Turn off power to equipment.
NOTE: Be careful not to nick or cut cables, material
hoses, or any other component in hose bundle.
2. Remove any necessary hose wrap and debris to
expose hose clamps needing replacement.
NOTE: Clamps are located near hose ends. Refer to
Fig. 1 for complete diagram of clamp locations.
3. Identify and remove necessary clamps from hose
using 3/16 Allen wrench.
Install the new clamp:
NOTE: Keep clamp square with the nearest modem
when installing.
4. Mark hose where clamp will be installed. (See
measurements in Fig. 1)
5. Place clamp halves around hose (Fig. 2).
6. Ensure that fiber optic strand (A side) and grounding
wire (B side) fit through the provided slots in clamp
(Fig. 3).
7. Install bolt into clamp and tighten using 3/16 Allen
wrench (Fig. 4).
8. Reinstall insulation onto material hoses, and cover
with jacket.
Fig. 2
Fig. 3
Fig. 4
WARRANTY POLICY
This product is covered by Binks’ materials and workmanship limited warranty.
The use of parts or accessories from sources other than Binks will void all
warranties. Failure to follow reasonable maintenance guidance provided can
invalidate the warranty.
For specific warranty information, please contact Binks.
For technical assistance or to locate an authorized distributor, contact one of our
international sales and customer support locations listed below.
REGION BINKS CONTACT
Americas Tel: 1-800-992-4657
Europe, Africa, Middle East Tel: +4401202571111
India marketingroa@binks.com
China Tel: +862133730108
Korea Tel: +82313663303
Japan Tel: +81457856421
Australia Tel: +61085257555
WARRANTY PAGE
Binks is a global leader in innovative finishing technologies.
Binks reserves the right to modify equipment specifications without prior notice.
Binks®, DeVilbiss® and Ransburg® are registered trademarks of Binks US, LLC.
